I N T R O D U C T I O N
The Alpha H3 heater produces radiant heat like the sun, warming people and objects rather
than the air in between. It is mounted on an adjustable bracket that allows the heat to be
directed exactly where it is required. The Alpha H3 can also be used in a modular system in
that more than one heater can be connected together
-
see ‘Configurations’ later in the
manual. The Alpha H3 weatherproof heater is designed for indoor and outdoor use.
Please read the following instructions carefully before use. The safety of this heater is
guaranteed only by its correct usage in accordance with these instructions, therefore
they should be retained for future reference.
Before using this appliance:
1.
Check that the voltage indicated on the units rating label corresponds to the mains
supply voltage.
2.
Do not install the heaters less than the minimum height from the floor as specified below
in the specification
-
Table. 1.
3.
Ensure that the heater has been securely fastened in its final mounting position.
4.
WARNING
-
This appliance must be grounded and hard wired!
5.
WARNING
-
Keep the mains cable away from the body of the heater which will get hot
during use.
6.
Do not cover or obstruct the heater while it is in use.
7.
Do not insert any object through any slot or opening in the heater.
8.
Do not use if guard is not present.
9.
When replacing the emitter or cleaning the unit, ensure that the
hard wired circuit(s) is
disconnected from the mains supply.
Note:
always ensure that the emitter is cool before
handling.
10.
Do not handle the halogen emitter with bare hands. If it is inadvertently
touched, remove finger marks with a soft cloth and methylated spirit or
rubbing alcohol. Otherwise, the marks will burn into the quartz emitter during
use causing premature heater failure.
11.
The heater is not intended for use by young children and must be supervised
by a responsible person at all times.
C A U T I O N
4