8.
Release the lamp emitter end by pressing the top edge of the spring clip away from the
lamp emitters ceramic end cap. Gently lift the end of the lamp emitter upwards so it is no
longer being retained by the clip (Fig. P). The wire can then be gently pulled from behind the
reflector.
9.
The lamp emitter wire at the opposite end should be pulled out of the side slot (Fig. Q)
and the lamp emitter can be lifted up completely. The wire can then be gently pulled forward
so that it also comes out from behind the reflector.
10.
The emitter can now be removed away from the heater leaving it ready to for the new
emitter to be fitted as shown in Fig. R.
Fig. R
Fig. Q
Fig. P
11
11.
Refit the new emitter in reverse order making sure that no wires can get trapped.
Replace the side reflectors/covers and their screws before any other parts are fitted to make
sure the emitter is held safely.
Continued on next page...
