5
Fig. C
Fig. D
A s s e m b l i n g - T w o S i n g l e H e a t e r s J o i n e d ( W a l l M o u n t e d o r
C h a i n H a n g i n g )
1.
Take the first heater and place it face down on a flat surface.
2.
Take the second heater and place it face down and positioned parallel to the first heater.
3.
Push the bolts used to hold the wall brackets through the hole in the brackets on the rear heaters and slide a shake-
proof washer on all the threads from the protruding side.
4.
Slide the joining bars on each bolt and fit a washer and nut – do not fully tighten at this point.
5.
Ensure the second heater is still parallel to the first and sitting flat.
6.
Slide the joining bars on each protruding bolt of the other heater to connect them together and fit the washers and nuts.
7. Again, ensuring the heaters remain flat, fully tighten all four nuts to secure the joining bars in place.
When two Alpha heaters are joined together they can be mounted in a
horizontal or vertical manner as the emitter is a universal burning type.
When wall mounting two Alpha heaters joined together in a horizontal
manner, do not position the heater at an angle more than 50° and less than
30° as shown in Fig. F.
Always allow the heater to cool before attempting to reposition/move.
Never attempt to move the heater while it is switched on!
Observe the minimum safe distance between the heater body and
inflammable surfaces and objects when mounting.
Please refer to Table 1 for the recommended positioning of the heater with
regards to minimum distances. Do not install the heater in a corner!
Keep out of the reach of children.
Fig. F
DRILLING HOLE TEMPLATE DIMENSIONS
FOR WALL MOUNTED BRACKETS
W a l l M o u n t i n g - T w o S i n g l e H e a t e r s J o i n e d
