CN3 (AUXILIARY)
NOT USED FOR REMOTE START
CN4 (INPUT / OUTPUT)
BLUE/WHITE - (-) 325mA DISARM
-
This wire sends a pulse to disarm the factory content alarm system before the
remote start sequence begins, with every unlock command, and trunk release. This wire can be programmed in Menu 1-06,
1-08, and 1-10 for different functions, it can also be programmed in Menu 4-02 for different outputs. Connect this wire to
either the factory disarm wire or door pin wire to control the factory alarm systems on most vehicles. This wire can also be
connected to the factory door pin wire to wake up a BCM on some vehicles that require this.
GREEN/WHITE - (-) 325mA REARM
-
This wire sends a pulse to rearm the factory content alarm system after the remote
start sequence ends, and with every lock command. This wire can be programmed in Menu 1-08 for different functions, it can
also be programmed in Menu 4-03 for different outputs. Connect this wire to the factory rearm wire to control the factory
alarm on most vehicles. This wire can also be used to pulse door pins to shut off auto lights, or rearm security on some
vehicles.
RED/WHITE - (-) 325mA TRUNK RELEASE
-
This wire will send out a negative pulse when the trunk command is
received. As default the doors will unlock before the trunk pulse is sent. This wire can be programmed in Menu 1-08, and
1-09 for different timing and features. It can also be changed to a latched output in Menu 4-01. Connect this wire to a
negative trunk wire on the vehicle. If the vehicle has a positive trunk release circuit please either use a relay or the PINK/
WHITE wire on CN1 and program Menu 2-01 to (+)Trunk.
PINK - (+) FOOT BRAKE STATUS INPUT
-
This wire is the brake shutdown wire and MUST be connected to the vehicle’s
(+) brake light wire when the foot brake is depressed. This wire will disengage the remote starter when 12V is applied, it
also is used for the tach learning process. NOTE - Some newer vehicles must have the ignition on for the brake lights to be
activated.
BLACK/WHITE - (-) PARK BRAKE STATUS INPUT
-
This wire is the emergency brake input wire and is required for
MANUAL TRANSMISSION installations. Connect this wire to the (-) emergency brake wire on the vehicle that goes to ground
when the emergency brake is engaged. This wire is used to set the remote starter into “reservation mode” and/or “turbo
timer” mode.
GREEN - (-) DOOR STATUS INPUT
-
This wire is the negative door status trigger input to the remote start and
detects when the door(s) are open. This wire MUST be connected to all doors on the vehicle when installed into a manual
transmission vehicle (or the (+) door status wire). Connect this wire to the vehicle’s wire that goes to ground when the door
is open.
PURPLE - (+) DOOR STATUS INPUT
-
This wire is the positive door status trigger input to the remote start and
detects when the door(s) are open. This wire MUST be connected to all doors on the vehicle when installed into a manual
transmission vehicle (or the (-) door status wire). Connect this wire to the vehicle’s wire that goes to positive (12V+) when the
door is open.
GRAY - (-) HOOD STATUS INPUT
-
T
his wire is the hood status trigger input to the remote start and detects when the
hood is open. This wire MUST be connected so that the remote start cannot engage when the hood is open or the vehicle is
being serviced. Connect this wire to the supplied hood pin switch and test to ensure that there is ground when the hood is
open and neutral when the hood is closed.
