SOLAC CE4501, Instructions For Use Manual, Page: 7 / 56

ENGLISH EN
USE AND CARE:
•
Fully unroll the appliance’s power cable before
each use.
•
Do not use the appliance if its accessories are
not properly fitted.
•
Do not switch the appliance on without water.
•
Do not use the appliance if the on/off switch
does not work.
•
Do not move the appliance while in use.
•
Respect the MAX and MIN levels.
•
Disconnect the appliance from the mains when
not in use and before undertaking any cleaning
task.
•
Unplug the appliance from the mains before
refilling the water tank.
•
Store this appliance out of reach of children
and/or persons with physical, sensory or re-
duced mental or lack of experience and knowl-
edge.
•
Do not store the appliance if it is still hot.
•
Only use water with the appliance.
•
The use of bottled mineral water adapted for
human consumption is recommended.
•
Never leave the appliance connected and un-
attended if is not in use. This saves energy and
prolongs the life of the appliance.
•
Do not remove the filterholder when coffee is
being made, as at that time it is under pres-
sure.
DESCRIPTION
A Water Tank Level
B Water tank
C Hot plate for warming cups
D/E Pilot light: ON/OFF and Heating
F ON/OFF Switch
G Coffee/Water Switch
H Heating Steam Switch
I Steamer pipe
J Filter holder
K Measuring spoon
L Filter for single measure (or POD)
M Ground coffee filter (2 cups)
N Supply cable
O Drip tray
P Drip Tray grid
R Steam/Water Knob
S Silicone tubes
INSTRUCTIONS FOR USE
BEFORE USE:
•
Make sure that all the product’s packaging has
been removed.
•
Before using this product for the first time, it is
advisable to test it only with water.
•
Before using the product for the first time, clean
the parts that will come into contact with food in
the manner described in the cleaning section.
•
Before connecting the machine, check that
Coffee/Steam Control Knob (R) is closed.
PRIMING THE CIRCUIT
This simple operation ensures optimum dis -
pensing and must be carried out:
•
When first starting.
•
When the tank has run out of water.
•
After obtaining steam.
•
Fill the receptacle taking care to observe the
MAX level.
•
Connect the appliance to the mains.
•
Push softly the ON/OFF Icon (F). The (D/E)
pilot light will light flashing meanwhile Heating.
•
You do not have to wait for the machine to heat
up for this operation.
•
Without fitting the filter holder (J) (or with the
filter holder fitted, but without coffee), place a
recipient under the steamer tube (I) outlet.
•
Open the Steam knob (R) turning anticlock-
wise.
•
Push the coffee/water icon (G).
•
Water will exit through the steam outlet. Wait
until approximately one cupful has exited.
•
To finish serving, push again over water/cof -
fee switch and close steam knob (R) turning
clockwise
•
This will complete the priming operation.
Attention with Icons activation:
•
Always press softly over the part closest to the
icons. Pressing in the middle zone between
two icons can make the unwanted icon work.
FILLING WITH WATER:
•
The tank must be filled with water before turn -
ing the appliance on.
•
Remove the water tank.
•
Fill the tank taking care to observe the MAX
level.