7
Instruction Manual
INOXA SERIES
GB
English
GB
NOTE:
numbers shown
below are referring to Fig. 1-
2 chapter 6 COMMANDS
DESCRIPTION to Page 4-5.
1.
Turn ON the generator by
turning the switch (20) in
position “1”.
2.
Press the pushbutton (1)
until the LED (1A) lights up.
3.
Turn the knob (7) to re-
gulate the welding current
value.
The value is visualized on
the digital display.
7.3 ELETRODE MODE SELECTION
1A
7
1
1A
7
1
HF
series
7.4 REMOTE CONTROL REGULATION
The welding current can be remote con-
trolled in the electrode mode using the
MANUAL remote control.
1.
Connect the 7-pin Plug of the remote
control to the Receptacle (15).
The display will blink for a few seconds.
2.
Set the welding current using the
remote control.
NOTE:
the welding current is regulated
from the minimum current of the machine
to the set current on the display.
Ex. If the I2 set current is 200A, the regu-
lation will be from 5A to 200A.
15
VRD = Voltage Reduction
Device.
If active, this fun-
ction reduces the no load
voltage of the machine to a
safe value (< 24V DC) as in
accordance with the interna-
tional standards.
1.
Press the pushbutton (1)
and turn ON the machine.
2.
On the display it will
appear the writing “VRD
OFF” or “VRD ON”.
3.
Press again button (1) to
set “VRD OFF” o “VRD ON”.
1
1
7.5 ATTIVAZIONE FUNZIONE “VRD“
NOTE:
if the machine is turned OFF with the VRD fun-ction active,
it will be ON at the next start-up.
HFP
series
HF
series
HFP
series
