Attach with
hot glue
Attach with
hot glue
Attach with
hot glue
Hull
Hull
Hull
Solar cell
Spacer
Spacer
Spacer
Motor
Motor bracket
Side view
Rear view
Solar cell
Glue the motor bracket onto the middle of the
spacer, let cool for 2 min.
Solder cable in place
Changes and error reserved, September 2018 / Christian Repky ©
A
B
Slide the motor into the motor bracket and attach the propeller.
C
D
E
Attach with
hot glue
Attach with
hot glue
Attention:
Solder the red cable
to the red dot!
Attach with
hot glue
Hull
Spacer
Apply hot glue to the spacer, then attach to the hull (approx.
from the edge). Let cool for 2 min.
45 mm
45.00 mm
Rear
round bow
15.00 mm
20.00 mm
Attach with
hot glue
Place the solar cell on top and apply hot glue all around.
If the solar place is glued
in place clean on all sides, the back of the solar cell will be protected from water.
Safety notes:
Keep this manual for future reference! It contains important information.
The soldering iron, solder and the parts being soldered become very hot. Be very careful!
Always use a mat when soldering! This prevents parts from slipping.
We recommend using a soldering iron holder to set the soldering iron down safely during use.
Attach with
hot glue
