Sokkia Axis 3, Operation Manual

Page: 36 / 54

Axis
3
Operation Chapter 4
Axis
3™
29
4.2.1 Other LED Conditions (OmniSTAR)
When powering on the Axis
3
receiver, both yellow LEDs and
the green LED may blink in sequence three times. If this is the
case, your OmniSTAR subscription on the receiver has expired.
Information on purchasing OmniSTAR subscriptions is
available through your Sokkia distributor. Refer to section
2.3.2.2 for more information.
4.3 Understanding Settings
The following sections identify the Axis
3
receiver configuration
settings required for correct operation. Many configuration
parameters are preset at the factory prior to shipment. Basic
settings that can be changed are:
• Baud Rate
• Message Output
• Differential Source
• Mask Angle
• Frequency and bit-rate selection
*
Note: Receiver parameters can be changed with a
connected data collector. Refer to your data collector
reference manual for more information.
Refer to the following table when making receiver adjustments.
Yellow
L-band/WAAS/Beacon differential signal
acquired, locked, and signal is strong
Table 2: LED Status Display
CAUTION
The changes you make to the Axis
3
receiver configuration are saved in mem-
ory for subsequent power-up
.