Example of mapping of statuses for device with index ”0” to
wacoSystem
alarms and back check of the settings
made:
cfg#alrb 0 0 2
WMBUS alarm bits [0] :
Burst - 2
cfg#alrb 0 1 1
WMBUS alarm bits [0] :
Leak - 1
cfg#alrb 0 2 4
WMBUS alarm bits [0] :
Baterry - 4
cfg#alrb 0 3 3
WMBUS alarm bits [0] :
Back flow - 3
cfg#
. . .
cfg#alrb 0
WMBUS alarm bits [0] :
Burst - 2,
Leak - 1,
Baterry - 4,
Back flow - 3
cfg#
The status ”0” is always considered as the basic ”fault-free” status. With this setting, the ”Burst” alarm is issued
when the status is changed from any to ”2” (for example, when the status was ”0” in the previous message and it is
”2” in the new one). Similarly, the ”Leak” alarm is generated when the status changes to ”1”, the ”Battery” alarm
when the status changes to ”4”, and the ”Back Flow” alarm when the status changes to ”3”. When the status
changes to ”0”, an ”OK” alarm is generated.
Current status of settings of all devices can be displayed by entering of ”alrb” command without parameters:
cfg#alrb
WMBUS alarm bits :
[0] -
Burst - 2,
Leak - 1,
Baterry - 4,
Back flow - 3
[1] -
Burst - 2,
Leak - 1,
Baterry - 4,
Back flow - 3
[2] -
Burst - 1,
Leak - 2,
Baterry - 3,
Back flow - 0
[3] -
Burst - 1,
Leak - 2,
Baterry - 3,
Back flow - 0
[4] -
Burst - 0,
Leak - 0,
Baterry - 0,
Back flow - 0
. . .
[18] -
Burst - 0,
Leak - 0,
Baterry - 0,
Back flow - 0
[19] -
Burst - 0,
Leak - 0,
Baterry - 0,
Back flow - 0
cfg#
The example shows a situation where statuses are read from four watermeters, the first two being of a different
type than the second two.
3.1.6
Commands for setting of message broadcasting system
This group of commands enables setting of system for radiobroadcasting of the information messages. There are
following commands:
ekey
setting of encryption key (”.” - encryption disabled)
periode
setting of regular messages broadcasting period
server
setting of target server IP-address
sport
setting of target server port number
sreply
redirection of replies to target server
apn
setting of private network Access Point Name (APN)
sess
maximum session time
testip
setting of IP-address for ICMP ping tests
tconn
connection setup timeout
tz
setting of time zone (UTC + n)
time
real time (RTC) displaying/setting (hh:mm:ss)
date
real time (RTC) displaying/setting (RR.MM.DD)
NB-K868
16