3
Overview
The CableMaster 500 is designed to test and measure lengths of
all common low voltage cabling found in today’s network, video or
telephone systems. It also maps the locations of cable ends by sending a
tone on the cable that can be traced with a tone tracer or by blinking the
LED on the port jack. The CableMaster 500 has a large, bright backlit LCD
display and glow-in-the-dark buttons to directly access each function.
The remote stores inside the main unit for ease of cable testing.
The CableMaster 500 is turned on by pressing the power button and
begins operating in the last mode used or the selected mode twisted
pair (DATA), coax (VIDEO), telephone (VOICE), tone generation (TONE) or
Port Link-Blink (LINC).
CableMaster 500 Features
Cable Verification
•
Test, Measure, and Map data, coaxial video and voice cables
•
Fault testing for opens, shorts, mis-wires, reverses and split pairs
•
Highly accurate length, opens and split detection using capacitive
technology
•
Port Link-Blink to visually identify connected ports on a switch or
router
•
Verify end-to-end grounding of shielded data cables
•
Single-ended testing for shorts
•
Wiremap testing to EIA T568A/B standards and cross-over cables
•
Loop mode for continuous testing
•
Recognizes up to 20 unique remote ID numbers for mapping cables
•
Built-in 4-cadence Tone Generator for audible tracing of cable runs
•
Auto-off and low power consumption for extended battery life
Conveniences
•
Built-in LED Flashlight
•
Easy-to-read Large Backlit LCD Display
•
Glow-in-the-Dark Buttons
•
Audible Beep for Additional Feedback
•
Ergonomic Slip-resistant Side Grips
•
Self-stored Master Remote - Squeeze remote at finger grip openings
in main unit to remove
•
RJ45, RJ12 and F-Jack on Main Unit and Remote
Summary of Contents for CableMaster CM500
Page 23: ...23 NOTES...