The hammer cannot work into the water if its level exceeds the tool stroke (see picture
down under), unless it is specifically made for this purpose.
In case of doubt contact the manufacturer.
Moreover, while the hammer is
working, we advice to shorten the
distance between excavator and
hammer as much as possible and to
remove the cylinder piston rods only
partially (C-D strokes never completely
out).
Make sure that the tool does not slip
from the surface (see picture). If the
tool is place wrongly or holds weakly
on the material, the dangerous
blank
firing
can occur
.
Yes
Yes
No
No
D
C
YES
NO
USE OF THE HAMMER
15
Page
of 48
4
Nederland B.V.
Summary of Contents for MDO 1600 TS
Page 34: ...44 39 41 43 45 36 35 38 40 42 46 37 STROKE CHANGER 34 Page of 48 10 Nederland B V ...
Page 40: ...101 96 98 100 99 97 DISTRIBUTOR GROUP 40 Page of 48 13 Nederland B V ...
Page 42: ...107 104 106 101 105 109 108 103 102 ACCUMULATOR GROUP 42 Page of 48 14 Nederland B V ...
Page 46: ...129 132 125 134 127 128 126 133 130 133 131 GREASING SYSTEM 46 Page of 48 16 Nederland B V ...