socomec ATyS FT, Installation And Operating Manual, Page: 33 / 78

ATyS FT - 549867A - SOCOMEC
33 EN
Bottom view
Top view
CAUTION ! Take care to correctly identify connectors when inserting “OUT1”, “OUT2” connectors,
“SOURCE 1”, and “SOURCE 2” connectors, as they are interchangeable.
The remaining connectors are included in connector kit (separate from harness) these can be used for customer input/
outputs, RS485 communication and current sensors.
6.4.3.2. User available connectors
For details on user available connection points refer to the table below:
(in grey connection points integrated in the harness in white available connection points)
TYPE TERMINAL N° DESCRIPTION CHARACTERISTICS
RECOMENDED
CROSS SECTION
TIGHTENING
TORQUE
Sensing
source 1
SOURCE 1
L1/L2/L3/N
Voltage sensing inputs source 1
& voltage supply (L1-L2)
Sensing voltage
50 - 575 V.a.c P-P - 50/60 Hz (+/- 10%)
Supply voltage (L1-L2)
88 - 576 V.a.c - 50/60Hz (+/- 10%) Ui 600V
AWG 18-14
0.75-2.5mm²
0.5-0.6 Nm
4.4-5.3 lb.in
Sensing
source 2
SOURCE 2
L1/L2/L3/N
Voltage sensing inputs source 2
& voltage supply (L1-L2)
Inputs
71 IN1: SWITCH IN POS1
Do not connect to any external power
supply
AWG 20-14
0.5-2.5mm²
72 IN2: SWITCH IN POS 2
73 IN3: DOOR OPEN
74 IN4: programmable input 4
75 IN5: programmable input 5
76 IN6: programmable input 6
70 Common point for inputs
Aux power
supply
81/82
- : negative terminal for aux supply
+: positive terminal of aux supply
12-24 Vd.c.
Outputs
12/14/11 OUT1: POS 1 ORDER
Dry contacts
8A / 277 VAC 50/60 Hz
5A / 24 VDC
AWG 16-14
1.5-2.5mm²
22/24/21 OUT2: POS 2 ORDER
32/34/31 OUT3: programmable output 3
42/44/41 OUT4: programmable output 4
52/54/51 OUT5: programmable output 5 (latching)
62/64/61 OUT6: genset start relay
Current
transformers
IN/I3/I2/I1 CTneutal/CTphaseC/CTphaseB /CTphaseA CT input 1A or 5A
Serial
connection
RS485
Connection RS485
-: negative terminal of RS485 bus
+: positive terminal of RS485 bus
NC : Ground
RS485 bus insulated
LiYCY shielded twisted pair
30-14 AWG / 0.14 to 1.5 mm² 0.22 -0.25 Nm
Digiware* DIGIBUS
Connection point for I/O 10 optional accessories &
digiware connection (must use 24 VDC input)
RJ 45 digiware cable - -
* For more information check I/O module instruction sheet ref 545597