SNR-S212i-8POE Installation Guide
Hardware installation
Shop.Nag.Ru 2016
37
Step 3
Insert the AC power plug into the power socket of the cabinet or the power sourcing
equipment in the equipment room.
4.5 Powering on device
Power on the SNR-S212i-8POE as below:
Step 1
After the SNR-S212i-8POE is properly installed, power on the device.
When the PWR LED is Green, the SNR-S212i-8POE is working with power.
Step 2
After self-check and initialization, the SNR-S212i-8POE enters the working status.
The interface LED indicates the working status (Green, Blinking green, or Off).
4.6 Check after installation
After installation is complete, check the SNR-S212i-8POE and environment as listed in Table
4-2.
Table 4-2
Check after installation
No.
Item
Method
1
Components are installed properly without loose ends or shedding phenomenon.
View.
2
Screws are tightened.
View.
3
Cables are correctly connected without loose ends or shedding phenomenon.
View.
4
The wiring of cables should meet design requirements.
View.
5
No damage, breakage, or middle connector for signal cables
View.
6
Labels on both ends of the signal cable should be correct, distinct, and neat.
View.
7
The radius of curvature of an optical fiber should be 20 times greater than the
diameter.
In general, it should be greater than 40 mm.
View.
8
The power cable and grounding cable should comply with engineering design
documents, to facilitate network expansion.
View.
9
Power cables and signal cables are laid separately.
View.
10
No stains or scratches on the surface of the device
View.
11
The fuse is big enough so that the device works properly under the maximum power
consumption.
Use a
multimeter.
12
When making the wiring nose of the power cable, grounding cable, or the alarm
cable, weld or clamp it tightly.
View.
13
The power cable and the grounding cable are properly connected. The spring shim
sheathes the flat shim.
View.
