SnowWolf AlphaBlower 36-106-P, Operation & Maintenance Manual

Page: 41 / 76

39 AlphaBlower Operation and Maintenance Manual
Maintenance
Auger Axle Couplings
Check the gearbox and the auger axle and axle
bearings for wear. Replace parts if necessary.
Cutout Clutch
The augers are secured using one cut out clutch.
The PTO shaft is secured by shear bolts.
Hydraulic Hoses
Check that there is no damage to hydraulic hoses
for the chute tilt and hydraulic swivel motor.
Replace any damaged hoses. Also check for any
leakages in hose connections and couplings.
Leaking fluids under pressure can enter the
skin and cause serious injury or death.
Immediate medical attention is required.
Wear goggles. Use cardboard to check for
leaks.
Cutting Edge Replacement
NOTE: Replace or flip the bolt-on cutting edge
when it wears within 1/2” - 3/4”.
Replace only with genuine SnowWolf
cutting edge and hardware.
1. Park the tractor on a level surface with the
snow blower properly attached.
2. Lower the snow blower approximately three to
four inches off the ground.
3. Engage the parking brake.
4. Shut off the tractor's engine, remove the
ignition key (if equipped), wait for all moving
parts to come to a stop and relieve all pressure
in the hydraulic lines.
5. Block and/or support the snow blower with
proper lifting device capable of sufficiently
supporting the unit's weight.
6. Disconnect PTO and hydraulic connections
between the snow blower and the tractor.
7. Block the cutting edge, remove the fasteners
and remove the cutting edge.
NOTE: Be cautious as the cutting edge and
hardware may be sharp.
8. Properly dispose of the old cutting edge’s and
install the new cutting edge’s by reversing the
steps listed here.
NOTE: Replace worn or damaged fasteners as
needed.