7
Unpacking
Carton Contents
• Electric wet/dry vacuum
• Trolley wheels (4)
• Screws (4)
• Vacuum hose
• Extension tubes (2)
• Wet floor brush
• Dry floor brush
• Crevice brush
• Dust brush
• Foam filter
• HEPA filter
• Registration card
1.
Carefully remove the electric wet/dry vacuum and check
to see that all of the above items are supplied.
2.
Inspect the product carefully to make sure no breakage or
damage occurred during shipping. If you find damaged or
missing parts, DO NOT return the unit to the store. Please
call the Snow Joe
®
+ Sun Joe
®
customer service center at
1-866-SNOWJOE (1-866-766-9563).
NOTE:
Do not discard the shipping carton and packaging
material until you are ready to use the wet/dry vacuum.
The packaging is made of recyclable materials.
Properly dispose of these materials in accordance
with local regulations.
IMPORTANT!
The equipment and packaging material are not
toys. Do not let children play with plastic bags, foils or small
parts. These items can be swallowed and pose a
suffocation risk!
Assembly
m
WARNING!
To avoid serious personal injury, read and
understand all safety instructions provided.
m
WARNING!
Do not connect to power supply until
assembly is complete. Failure to comply could result in
accidental starting and possible serious personal injury.
m
WARNING!
Before performing any maintenance, make
sure the tool is unplugged from the power supply. Failure to
heed this warning could result in serious personal injury.
m
WARNING!
To prevent personal injury, make sure the
switch is in the OFF position before attaching or removing the
vacuum hose.
1.
Release the power head by grabbing the two lid locks and
pulling outside to unlock. Then remove the power head
(Fig. 1). All accessories and wheels are stored inside the
dust tank.
2.
Turn the dust tank upside down, and insert the 4 trolley
wheels into the holes on the bottom of the dust tank. Press
the wheels down firmly and screw in to secure (Fig. 2).
Fig. 2
Dust tank
Trolley
wheels
3.
Insert the vacuum hose in the air inlet/hose connector,
and push firmly to secure (Fig. 3).
Fig. 1
Lid lock
Power head
Fig. 3
Vacuum hose
Air inlet/hose
connector