8
1. Position the washer as CLOSE as possible to the water
supply.
2. The washer must be used on a secure and stable surface
in a standing, upright position (Fig. 8).
Fig. 8
3. Make sure the unit is switched off before plugging the unit
into the power outlet.
4. Check that the electrical supply voltage and frequency
(Volt/Hz) correspond to those specified on the rating plate.
If the power supply is correct, you may now plug the
pressure washer into the power outlet (Fig. 9).
NOTE: The GFCI may need to be reset when first plugged
into the electric outlet. Press the “Reset” button until
the power light indicator on the GFCI illuminates when
plugged in.
5. Turn the water supply tap on completely.
6. Push to release the safety lock, then press the trigger for
a few seconds until the water flow is steady. This step will
allow air to escape and discharge residual pressure in the
hose (Figs. 10 – 11).
GFCI
Power light
indicator
Reset
Fig. 9
7. Turn the ON/OFF switch to the ON (I) position to start the
pressure washer (Fig. 12).
8. When re-starting the motor, always keep the trigger
pressed.
NOTE: The motor only runs when the trigger is operated
and shuts off when the trigger is released.
Safety
lock
Fig. 10
Trigger
Fig. 11
Fig. 12
