SNOWJOE SunJoe MJ24C-14-XR, Operator'S Manual

Page: 12 / 23

12
4. Once the machine powers on, release the safety lock
button and proceed with operation, gently lowering the
mower down into the cutting position (Fig. 14).
5. To stop the mower, release the switch lever.
m
WARNING!
The mower blade will continue to rotate for
a brief period after the unit has been switched off. Do not tilt or
carry the unit while the motor is still running and do not touch
the blade while it is still rotating. Failure to comply could result
in severe personal injury.
Adjusting the Cutting Height
Follow these instructions to adjust the cutting height of the
lawn mower.
m
WARNING!
Before making these adjustments,
disconnect the power supply to the mower by plugging
out the safety key from the slot, and wait until the rotating
blade has come to a complete standstill. Wearing gloves is
recommended due to the close proximity of the cutting blade.
ALWAYS FOLLOW ALL SAFETY PRECAUTIONS AND
RECOMMENDATIONS LISTED PREVIOUSLY IN THIS
MANUAL.
1. Power off and remove the safety key from the slot.
2. Remove and empty the grass collection bag.
3. Place the lawn mower on its side.
4. The wheel axles can be placed into 3 different cutting
heights: low (will cut grass the shortest), medium, and high
(Fig. 15).
3-Position Height Adjustment:
1. Low: 1.18 in. (30 mm)
2. Medium: 1.93 in. (49 mm)
3. High: 2.52 in. (64 mm)
The cutting height tolerance is +/- 5 mm (+/- 0.2 in.).
5. Move all four wheels to the desired cutting height by
pulling back on the rod axle and setting it to the desired
position. Make sure all four wheels are at the same cutting
height position.
NOTE: Set the mower to the highest cutting height when
mowing on uneven ground or in tall weeds.
6. Place the lawn mower back on to its wheels and reattach
the grass collection bag.
7. Insert the safety key into the slot and resume normal use.
Fig. 13
Switch lever
Safety lock
button
R
Fig. 14
Fig. 15
High setting
Medium setting
Low setting Rod axle