15
2.
Take off the bar sheath.
3. Make sure the guide bar is not touching the ground or
any other object.
4.
Hold the pole chain saw firmly with both hands.
5. To turn the tool ON, push and hold the safety lock switch
on the top of the handle grip with your thumb and then
squeeze the trigger switch with your fingers. Once the
tool is running, you can release the safety lock switch and
proceed with operation (Fig. 19).
NOTE: Do not press the trigger switch until you are ready
to make a cut.
6. To turn the tool OFF, release the trigger switch.
7. Lift the push lock button and pull out the battery (Fig. 14).
Adjusting the Telescoping Pole
1.
Turn off the trigger switch.
2. Unclip the cam-lock to release the pole (Fig. 20).
3. Extend the pole to the desired length (Fig. 21).
NOTE: Push poles toward each other to shorten the pole
or pull them away from each other to lengthen the pole.
Only extend the pole to the minimum length required to
reach the limb to be cut.
4. Lock the pole in position by closing the cam-lock (Fig. 22),
and ensure that the pole is secure. If the pole telescopes
when the cam-lock is closed, the nut may need tightening.
m
WARNING!
Failure to lock the telescopic pole cam-lock
as directed could result in personal injury.
Tightening the Bolt
The retaining bolt may need tightening to secure the telescopic
pole in place.
1. Unclip the cam-lock. Using a hex key wrench, tighten the
cam-lock nut, then close the cam-lock. Ensure that the
pole is secure. The wrench may be required to loosen the
cam-lock nut if you need to adjust the pole to a different
height (Fig. 23).
Fig. 19
Safety lock switch
Trigger switch
Fig. 20
Cam-lock
Fig. 21
Telescopic pole
Fig. 22
Cam-lock
Fig. 23
Hex key wrench
Cam-lock nut
