SNOWJOE iON24SB-XR, Operator'S Manual

Page: 15 / 28

15
To Engage Auger
NOTE: Auger trigger should be engaged before drive trigger
when throwing snow.
1. To engage the auger, press the safety button then squeeze
the auger trigger against the right-handle (Fig. 22).
2. Release auger trigger to stop the auger.
IMPORTANT! DO NOT overload unit capacity by attempting to
clear snow at too fast a rate. Use slow speed to clear deep or
hard packed snow.
To Engage Drive
1. In the control panel, select a speed appropriate for a pace
you’re comfortable with (Fig. 23).
2. Squeeze drive trigger against the left-handle and the snow
blower will move. Release it and drive motion will stop
(Fig. 24).
IMPORTANT! Forward speed can be changed without
releasing the drive trigger (left-handle).
m
WARNING!
DO NOT change direction from forward
to reverse with drive trigger (left-handle) engaged. Unit
must come to a complete stop before changing direction.
Snow Removal
NOTE: Auger trigger should be engaged before drive trigger
when throwing snow.
1. Press the safety button then engage auger trigger. Auger
will start spinning (Fig. 25).
2. In the control panel, select the appropriate speed for the
snow conditions and a pace you’re comfortable with
(Fig. 25).
3. Engage drive trigger. The snow blower will move and start
plowing snow (Fig. 25).
IMPORTANT! Disengage the auger trigger when reversing.
Fig. 22
Safety button
Auger trigger
(Right-handle)
1
2
ON
OFF
Fig. 23
Reverse
Forward
Speed 1 | Speed 2 | Speed 3
Fig. 24
Drive trigger
(Left-handle)
2
4
Fig. 25
Drive trigger
(Left-handle)
Auger trigger
(Right-handle)
Safety
button
1
3
Speed 1 Speed 2 Speed 3