14
Replacing the Plastic Auger
NOTE:
When replacing worn plastic plates, pay close attention
to any different types of bolts and nuts and where they are
positioned. This will ensure that the new plastic plates are
installed properly and securely.
1.
Open the two side covers by removing the 4 screws on
each side (Fig. 24).
2.
Remove the belt from the drive wheel (Fig. 25).
3. Remove the drive wheel by turning it clockwise
(Fig.
26).
4
. Remove the screws and washer on the other side, and
remove the auger axle (Fig
s.
27 – 28
).
5.
Remove the old auger from the housing (Fig. 29
).
6. Install the replacement auger by following the above steps
in reverse order.
Fig. 24
Screw
Side cover
Fig. 25
Belt
Drive
wheel
Fig. 26
Drive wheel
Fig. 27
Screw
Washer
Fig. 28
Auger axle
Fig. 29
Old auger
