18
Replacing Auger Belt
Tools Required (Not Provided):
• 10 mm wrench (2)
• Needle nose pliers
• Heavy duty gloves
1.
Position unit on a hard, flat, smooth level surface, with the
battery (or batteries) removed.
2. Use 2 10 mm wrenches to remove the bolts and nuts that
are used to fix the right side panel. Then remove the right
side panel to expose the belt, as shown (Fig. 26).
NOTE:
The 2 bolts located on the left have 2 nuts on the back,
while the other 4 bolts don't. Use one 10 mm wrench to hold
the left two bolts steady and remove the nuts with the other 10
mm wrench first, and then remove all the bolts.
3. Use the needle nose pliers to remove the spring from the
hook to release the belt tension (Fig. 27).
4. Remove the drive belt by slowly turning the auger pulley
counterclockwise while pulling the belt outwards (Fig. 28).
5.
Install the new drive belt, rotating it onto the pulleys
(Fig. 29).
NOTE:
Rotate the new drive belt first around the engine pulley,
then the idle pulley, and finally around the auger pulley. Slowly
turn the auger pulley clockwise to drive the belt inwards
(Fig. 30).
6. Use needle nose pliers to reinstall the spring onto the
hook to tension the belt. Replace the side panel on the
unit, secure with the original hardware. The snow blower is
ready to use.
Fig. 26
Right side
panel
Bolts
Nuts
Old belt
Fig. 27
Needle nose
pliers
Spring
Fig. 28
Drive belt
Auger pulley
Fig. 29
New drive
belt
Fig. 30
Spring
Spring hook
Engine
pulley
Idle pulley
Auger pulley
Belt
Summary of Contents for iON100V-21SB-RM
Page 24: ...snowjoe com...
