Lit. No. 76616, Rev. 02
11
November 15, 2018
Wood Spacer
INSTALLATION INSTRUCTIONS
5. Install any optional kits and equipment. To install the
BRM-175 Adjustable Boom Receiver Mount, unfasten
the rear brake light, install the kit, and re-install the
light on the top rear face of the BRM bracket.
6. Securely bolt and strap unit into place on the
vehicle bed using the optional UMK-200 Universal
Mounting Kit or similar brackets and ratchet straps.
Hardware attaching the sprayer system directly to
the vehicle is the responsibility of the end user.
NOTE: Pay special attention when drilling or
clamping dissimilar metals to aluminum bodies.
Galvanic corrosion can occur if not handled
properly. Contact vehicle manufacturer for
recommended attachment practices.
7. Measure the distance between the front of the
truck bed and the tank base. Make a spacer to
fi
ll
area between the tank base and the front of the
truck bed. Failure to install this spacer could result
in damage to the sprayer and/or vehicle.
8. Install the boom so that the nozzles measure
18"–22" from ground to nozzle tip. This is to
prevent damage and ensure optimal performance.
Consider using the optional BRM-175 Adjustable
Boom Receiver Mount if the tips of the nozzles lie
outside this zone when using your stock receiver
hitch.
9. Connect the boom to the pump. Clamp the quick
disconnect attachments on the boom hoses to the
manifold valves on the pumping unit. Route the
hoses to the installed boom with adequate slack
and cut the hoses to
fi
t. Clamp the hose tightly to
the boom to prevent leaks.
CAUTION
Ensure that nozzles have minimum 18 inches
ground clearance. Low boom heights can
cause accidental breakage from curbs,
uneven surfaces, and other obstacles.
Adjustment may require optional BRM-175
Adjustable Boom Mount.
18"–22"
2
3
1
1
2
3
