© Trynex International 2011
14
Center High Mount Stop Lamp (CHMSL)
Model # SP-6000 Only
• With spreader mounted on vehicle, plug vehicle (CHMSL) harness into spreader stop lamp harness.
•
Using supplied harness clamps and screws, route harness along side wall lower corner or so that harness will be out of the way when
spreader is in use.
•
Locate vehicle ground wire and stop lamp power wire at rear of vehicle. Use supplied wire taps to connect harness to vehicle electrical
system. Once wire taps are installed check to make sure stop lamp works when brake pedal is pressed. Properly complete installation by
tying up any loose wires with ty-wraps, also add electrical tape over both connections to insure a solid electrical connection. Some newer
trucks have auxiliary stop lamp power leads already at the rear for these types of applications.
Key Part# Description
Oty
1
D6158 Nut | #10-32 Nylox Zinc
2
2
D6514 CHMSL Brake Light
1
3
D6529 #10-32 X 1-1/4” Phil Pan
2
Key Part# Description
Oty
D6234 Butt Connector | 12 Gauge 2
D6487 Screw | #8 X 1/2”
1
4
D6513 Vehicle Harness | CHMSL
2
D6523 Scotch Lock Yellow
4
D6561 Clamp | 1/2” Nylon
4
2
3
4
1
CHMSL Spreader Harness
(installed on Spreader from factory)
CHMSL Vehicle Harness
Route along bed
Black Ground (-)
White Positive (+)
Splice into vehicle
harness stop lamp/
CHMSL circuit.
Rev. 02