Page 9
9
9
9 of 16
16
16
16
5.11.
Location based service (LBS)
When the tracker device doesn’t receive valid GPS signals, tracker will locate by LBS, the messages
includes the GPS coordinates of the last position in SMS mode, but the LAC in message is the current
new position, the location can be seen by input the LAC code in the menu “Manual Track” of web
platform http://gts.snowbean.com.au, you can also send command “PASSWORD” to
tracker to get the newest absolute address and newest GPS coordinates as well; tracker will
automatically switch to track by location based service in GPRS mode, and actualized on the map of
web server with LBS mark
. And there may be some inaccuracy with actual location by LBS tracking;
the bias depends on GSM reception.
Note: This feature can be used normally in most areas according to the signal of GSM network. It may
not be available in some areas.
5.12.
Monitor (Voice Surveillance)
The command to switch between Track and Monitor are “tracker” and “monitor”. The default mode is
“track” (Track mode).
Send SMS “password” to the unit, and it will reply “monitor ok!” and switch to “monitor” mode.
Send SMS “password” to the unit, it will reply “tracker ok!” and restore to “track” mode.
5.13.
Data logging
Auto logging
：
：
：
：
When the tracker devices lost GSM signals or fall offline from GPRS, tracker will store
the tracking position and alerts automatically in the flash upon the pre-set condition, when GSM
signals get back, all the event alerts will be auto-sent to the authorized numbers or monitoring
platform (server), but the stored tracking data should be loaded to the monitoring platform via SMS
command.
Logging upon times:
Send SMS: “SAVE0PASSWORD” to the tracker unit, it will reply
“SAVE OK”, and will store the lat, long locations every 30 seconds for 5 times. (
s: second, m: minute;
h: hour).
Multi-logging
：
：
：
：
Send SMS: “SAVE030S***N+ PASSWORD” to tracker device, it will reply “SAVE OK”.
Logging Clearance:
send SMS: “clear+ password” to tracker device, it will reply “clear ok”.
Note: logging volume: built-in flash 1MB (store about 16,000 positio
ns);
TK102B supports an external
SD card (maximum 2GB).
The logged data can be copied to computer via the USB cable. The route of the stored data can be
seen by importing data in the menu “Data Import” of web platform http://gts.snowbean.com.au/
5.14.
Data Load
Current date Load:
Send SMS: “load+ password” to tracker device, it will reply: “load ok” if the device
is working well under GPRS mode; if not, it will reply “load fail! Please check gprs” that means device
does not work under GPRS mode.
Specified date Load:
Send SMS: “load+ p space+ year month date” to tracker device, it will
reply: “load ok” and load the tracking data to the monitoring platform upon the valid time you choose.
