Snow Lizard SLXtreme 7, User Manual

Page: 10 / 15

[ 10 ]
LED Behavior while Charging
Testing Waterproof Ability
Before Use
The LEDs will indicate charging progress while your
SLXtreme is plugged into a power source.
When the battery has reached a full charge, the
LEDs will stop blinking.
• LED 1 steady blue = 0–25%
• LED 1 & 2 steady blue = 26–50%
• LED 1, 2 & 3 steady blue = 51–75%
• LED 1, 2, 3 & 4 steady blue = 76–100%
Your SLXtreme 7 case is IP–68 rated and is
designed for submerging in water down to 2 meters
(6.6’) for up to 30 minutes.
Before using your SLXtreme 7 for the first time, test
the case by placing a paper towel in the case and
close and latch the bottom cover (instructions on
following page.)
When closing the case, keep the bottom cover
seal free from debris and sand to prevent any
leakage. Be sure to check that the audio jack plug is
tightened and not loose.
Submerge the case 0.3 m (1’) underwater for
30 minutes to ensure the case is not leaking or
defective. We recommend doing this a few times
a year and after major drops to ensure the case’s
integrity and waterproof ability remain intact.