1. Safety
■
Safe Operation
The following safety information is vitally
important for safe operation of the ATB 42/50.
Failure to follow these instructions can result in
personal injury or DEATH.
❑
Pre-Start Inspection
At the start of each work shift, the ATB 42/50
shall be given a visual inspection and function
test. See the “Daily Inspection and Maintenance”
chapter 7, in this manual for a list of items to
inspect and test.
DO NOT operate the ATB 42/50 unless you
are trained and authorized, understand the
operation characteristics of the ATB 42/50,
and have inspected and tested all functions to
be sure they are in proper working order.
❑
Work Place Inspection and Practices
Do not use the ATB 42/50 as a ground for
welding. Ground to the work piece.
Before the ATB 42/50 is used, and during use,
check the area in which the ATB 42/50 is to be
used for possible hazards such as, but not limited
to:
1. Drop-offs or holes.
2. Side slopes.
3. Bumps and floor obstructions.
4. Debris.
5. Overhead obstructions and electrical
conductors.
6. Hazardous locations.
7. Inadequate surface and support to withstand
all load forces imposed by the aerial platform
in all operating configurations.
8. Wind and weather conditions.
9. Presence of unauthorized persons.
10. Other possible unsafe conditions.
Before the ATB 42/50 is used, determine the
hazard classification of any particular atmosphere
or location according to ANSI/NFPA 505-1987.
Any ATB 42/50 operated in a hazardous location
must be approved and of the type required by
ANSI/NFPA 505-1987.
A recommended safety practice is to have
personnel that are trained in the operation of the
emergency controls working in the immediate
area of the ATB 42/50 to assist the platform
operator in the event of an emergency.
When moving the platform, check the clearance
around the ATB 42/50 to avoid contact with
structures or other hazards. Always look in the
direction of motion.
Keep ground personnel from under the platform
when the platform is raised.
Secure all accessories, containers, tools, and
other materials in the platform to prevent them
from accidentally falling or being kicked off the
platform.
DO NOT engage in any form of “horseplay” or
“stunt driving” while operating the ATB 42/50.
DO NOT permit riders on the machine anyplace
other than on the platform.
Remove all loose objects stored in or on the
machine, particularly in the platform. Remove all
objects which do not belong in or on the machine.
When other moving equipment is in the area,
take special precautions to comply with local
regulations regarding warnings.
Never steady the platform by positioning it
against another platform.
DO NOT operate an ATB 42/50 that is not
functioning properly, or has been damaged, until
the machine has been repaired by a qualified
maintenance person.
DO NOT operate an ATB 42/50 that does not
have all its decals and placards attached and
legible.
Drive the machine with care and at speeds
compatible with conditions. Use extra caution
when driving over rough ground, on slopes, and
when turning.
Know and understand the job site traffic flow
patterns and obey the flagmen, road signs, and
signals.
Watch for bystanders and never allow anyone to
be under, or to reach through, the machine and
its equipment while operating.
Use the recommended transport device when
loading the machine.
ATB 42/50 – 0161987
page 1 - 1
CAUTION
