UK • 7
Return to contents
Installing the 4ZERO Elite BT
For optimal results mount the 4ZERO Elite BT onto the vehicles windscreen or alternatively mount it on to the dashboard.
When installing your 4ZERO Elite BT please consider the following:
●
●
The unit, with its built in GPS antenna has a clear view of the sky*
●
●
It is located in a position where you can easily view the OLED display without having to take your eyes too far from the road
ahead and that you can reach the controls safely.
●
●
When the power cable is attached it must not impede the safe operation of the vehicle or its controls.
●
●
The positioning of the device must not impair the driver’s vision.
●
●
Does not jeopardise the drivers or passengers safety
●
●
You will be able to remove the device when the vehicle is left unattended and to perform downloads.
Please Note: Some vehicles may come with a ‘Solar Reflective’, ‘Metal Oxide’ or ‘Athermic’ windscreen which will affect the
performance of the built in radar laser detector. If your car has this type of screen try and locate a section of the screen
that is clear. This can sometimes be found near the rearview mirror or at the centre of the screen just above the dashboard.
Unfortunately if your car windscreen does not have a clear area it will not be possible to use the 4ZERO Elite BT. If you are unsure
what type of windscreen is fitted to your vehicle then please contact your local vehicle dealer or manufacturer for further
information.
Once you have found a suitable location for your 4ZERO Elite BT secure it in place by using the suction cup windscreen bracket or
hook and loop fastener, remembering to clean the area where the bracket is going to be positioned thoroughly before hand to
ensure good contact. More detailed installation instructions follow.
PLEASE NOTE: Be careful to choose a location that does not block the drivers view or where it might endanger the driver or
passengers should your vehicle suddenly come to a stop or be involved in an accident.
Installing your 4ZERO Elite BT using the Windscreen Suction Cup bracket
You can mount your 4ZERO Elite BT to the inside of your vehicles windscreen using the suction cup windscreen bracket provided.
Simply select a position within the windscreen so that the top of the unit has a clear view of the sky, remembering that you need to
connect the power cable as well as ensuring that you can read the display and reach the controls safely.
●
●
Install the suction cups onto the bracket by fitting them into the holes (if required).
●
●
Clean the area where you wish to position the bracket thoroughly with a good quality glass cleaner
●
●
Adjust the bracket to the rake of the windscreen by carefully bending it so that when the 4ZERO Elite BT is mounted onto the
windscreen it is perpendicular to the road ahead. The display must be facing the driver and the controls should be within reach of
the driver.
Installing your 4ZERO Elite BT using the Hook and Loop Fastener
The 4ZERO Elite BT can be installed anywhere on the dashboard as long as the built in GPS antenna has a clear view of the sky and
you can easily see the display and operate the controls safely. You will also need to be sure that you can connect the power cable.
Your 4ZERO Elite BT can be installed easily with the hook and loop fastener provided if you have a sufficiently flat area on your
dashboard.
●
●
Use an alcohol wipe or similar cleaner to thoroughly clean the bottom of your 4ZERO Elite BT and the area of the dashboard
where you intend to mount your unit.
●
●
Apply the ‘hook’ portion of the fastener to the dashboard and the ‘loop’ portion to the underside of your 4ZERO Elite BT.
DO NOT leave the unit in view when the car is stationary during hot conditions. Exposing the 4ZERO Elite BT to extremely high
temperatures can temporarily impair performance. Keep the 4ZERO Elite BT out of sight when not in use to help avoid theft.
4Zero Elite BT V1.0 EN 05/18
Summary of Contents for 4zero Elite BT
Page 1: ...User manual...
