8
24. Apply dielectric grease to all light harness
connectors. Connect the plow light harness with the
black male connector to the driver side lamp and the
plow light harness with the black female connector to the
passenger side lamp.
25. Check operation of all lamp functions (Low beam
headlamp, high beam headlamp, marker lights and
directional signals).
26. Aim plow lights with plow in the fully raised position.
Lock the lamps in the adjusted position by tightening four
1/4" x 7/8" horizontal adjustment screws and one 1/4" x
7/8" vertical adjustment screw and 1/4" nut securely (See
Figure 1-12 and Figure 1-13.
NOTE: In order to conform to Federal Motor Vehicle
Safety Standards a SAE J602 Approved aiming device
must be used to aim plow lights.
Install an end cap in each end of the light bar (See Figure
1-13).
Mounting Snow Plow To Vehicle
1. Drive truck into plow. Align light/lift bar frame outside
of subframe lugs. Pins should fit inside slots cut into
subframe lugs. (See Figure 1-14).
Figure 1-14
NOTE: If pins are too high or low to fit into slots on sub-
frame, adjust the height by plugging in the plow and hand
held controller.
For Down Pressure Plows
- To lower the
pins, turn on down pressure and press down. To raise the
pins, press up.
For Gravity Plows
- To lower the pins,
place plow in float and push up on light bar. To raise the
pins, press up.
2. Plug in power harness and remove controller from
truck cab. Plug controller into plow.
3. Rotate light/lift bar into position by turning on down
pressure and pressing the lower button. (See Figure 1-
15).
SUBFRAME
LIGHT / LIFT
BAR FRAME
MOUNTED
ON TRUCK
WARNING
When using the hand held controller to raise or
lower the plow A-frame for mounting the plow
to the vehicle, be especially careful of the
movement of the light bar. This movement will
occur when raising or lowering the A-frame or
jack stand.
FAILURE TO FOLLOW CAN RESULT IN INJURY
OR DEATH
WARNING
Pressing the blade angle functions will result in
the A-frame swinging if it is not secured to the
truck. Do not press the angle function during
plow installation.
FAILURE TO FOLLOW CAN RESULT IN INJURY
OR DEATH
WARNING
The power cable in front of the truck is wired
directly to the battery. The power cable is
always energized, even if the truck is turned off.
Always replace the protective cap after
disconnecting the plow power cable. Allowing
an unprotected plug to contact metal parts of
the truck may cause electrical component
damage. Never use a metal object to clean the
plug contacts.
FAILURE TO FOLLOW CAN RESULT IN INJURY
OR DEATH
Summary of Contents for 22 Series
