MV-805 IP Multiviewer User Manual
Initial MV-805 Unit Configuration with RollCall
Getting Started 1 - Unit Settings (RollCall Template) 7.2
Issue1 Revision 1
Page 81
© 2018 SAM
7.2 Initial MV-805 Unit Configuration with RollCall
Initial unit configuration can be done with RollCall Control Panel and should be carried out on
a separate IT network, separate from any house media network.
Initial unit configuration sets up MV-805 unit IP addresses and communication settings etc. to
prepare the unit for connection to networks.
Finally, a unit service reset is performed from the RollCall template which restarts the unit.
Once the MV-805 has re-booted after initial configuration, the new network settings will be
adopted and the unit can then be connected to your house media network and any further
configuration can be done.
7.2.1 Setting Up the Host Name
With RollCall Control Panel connected to the unit:
1.
Select the
System-Setup
template, see Figure 53.
2.
Look at the
Network Settings
section of the template. See Figure 54.
3.
Enter a
Host Name
. Press
S
to save the change locally.
Note:
See Section 6 “RollCall Templates” on page 46 for descriptions of settings;
in particular, see Section 6.2 “System-Setup Template” on page 49.
Figure 53 Select the System-Setup Template
Figure 54 ‘Network Settings’ section of System-Setup Template
Figure 55 Enter Host Name and Press “S” to Save Locally
Press
S
to save a change locally
