MV-805 IP Multiviewer User Manual
System-Setup Template
RollCall Templates 6.2
Issue1 Revision 1
Page 59
© 2018 SAM
6.2.6 “Router Controller Settings” box
The MV-805 IP Multiviewer typically monitors video IP streams which are routed around an IP
routing system which comprises a media IP network configured for video IP routing. In such a
SAM IP network, the traditional video router device is replaced by a high-performance
network IP switch which is under the control of a router controller device.
Information about the router controller device is set up in this
Router Controller Settings
box.
The MV-805 IP Multiviewer can get video signal name information via its RollCall interface.
The MV-805 IP Multiviewer acts like a control panel when getting signal names, as far as a
router controller is concerned, and uses the SAM SW-P-08 protocol.
The
Router Controller Settings
box is shown in Figure 34 and the settings are described in
Note:
Router Controller of IP Routing System (IP-RSC):
A Router Controller device for a SAM video IP routing network is the IP-RSC unit. It
presents the IP routing network as a traditional video router to the user and to other
devices. This enables the network to be controlled through traditional hard/soft control
panels and control systems (via SAM’s SW-P-02 and SW-P-08 protocols).
The router controller keeps a list of user-friendly video signal names.
The router controller for a video IP routing system has network interface(s):
a
connected to control panels etc. (for control messages).
b
connected to IP edge devices (for IP routing messages).
Note:
Multiviewer Input Spigots:
The MV-805 IP Multiviewer’s (IP) video input spigots are connected to destination ports of
a video router.
•
The destination port number range used by the multiviewer’s input spigots must be
contiguous.
•
The size of the port number range is determined by the number of multiviewer
video inputs.
Figure 34 Router Controller Settings Box
For RollCall connection to
the ‘traditional video router control’ side of a SAM IP Routing System Controller unit.
