SNBC BTP-M280, User Manual

Page: 9 / 39

BTP-M280 User’s Manual
- 5 -
2.2 Cutter specification
Item Parameters Remark
Cut method Sliding blade
Cut time 600ms Time for one cutter action
Cut interval 2s 30 cuts/minutes (Max.)
Adapt Paper 65
～
100 μ m Normal paper with same thickness
Operation voltage 24VDC
Max. repose current 1.2A 24VDC
Cutter lifetime 1,000,000cuts Under standard test conditions
2.3 Paper Specification
2.3.1 Continuous paper
1 ） Normal paper
¾ Paper width: 80±0.5mm/76±0.5mm/69.5±0.5mm/57.5±0.5mm
¾ Max. paper roll O/D: Φ 83mm
¾ Paper roll core: ID Φ 12.5mm; OD Φ 16mm
¾ Paper thickness: 0.06—0.085mm
2 ） Multi-layer paper (1 or1 copies)
¾ Paper width: 80±0.5mm/76±0.5mm/69.5±0.5mm/57.5±0.5mm
¾ Paper thickness: 0.05—0.08mm, total thickness ≤ 0.14 mm
Caution:
— Use only multi-layer paper (1 or 1 copies) of which the original layer on contact the print
head thicker than its under-layer.
2.3.2 Marked paper
Besides the requirements of the continuous paper, marked paper should follow the following
requirements:
1)
Mark place
y BTP-M280 printer reserves 8 positions for mark sensor,
which can detect marks on either the front side or the
reverse side of the paper. Position of the sensor is as shown
in the figure.
y The position of the mark sensor can be adjusted according
to user’s need. The default position (Position 1) is on the
right side of the paper on the front side (paper feed direction)
as shown in the figure.
2)
B/M size should meet the requirement as follow:
y Mark width (L1) ： 5mm ≤ L1 ≤ 10mm
y Mark height (L2)
：
12mm ≤ L2 ≤ paper width
y
Distance between marks (L3)
：
20mm ≤ L3 ≤ 500mm
3)
The black mark’s reflectivity should be less than 15%, and the other part’s reflectivity should be
more than 85%. There should be no image between the two marks, such as the advertisement etc.