Snapper WMRP216517B, Safety Instructions & Operator'S Manual

Page: 8 / 28

8
Section 2 - OPERATING INSTRUCTIONS
WARNING
DO NOT attempt any maintenance, adjustments or
service with engine and blade running. STOP engine
and blade. Disconnect spark plug wire and secure
away from spark plug. Engine and components are
HOT. Avoid serious burns, allow sufficient time for
all components to cool.
2.6 RECYCLING
OPERATION
NOTE: For best recycling results, cut up to a maximum
of 1/3 of grass blade length and recycle ONLY when
grass is dry.
1. Set all wheels in the highest cutting position
(Notch 6).
2. Move engine speed control to “FAST” (Rabbit)
position.
3. Move ground speed control to slowest speed
setting.
4. Proceed mowing slowly. If grass is very dense,
lower each rear wheel latch one notch lower than
the front wheel latches to improve recycling
performance.
INSTALLATION of GRASS BAG ADAPTER
(Optional Accessory on Some Models)
STEP 1: Install the grass bag adapter and secure to the
side and top of the deck with the two nuts provided with
the machine. Slot in front edge of adapter must be under
nut located on top of deck. See Figure 2.7.
FIGURE 2.7
INSTALLATION of RECYCLING PLUG
(Optional Accessory on Some Models)
STEP 1: Once adapter has been installed, recycling may
be desired. Insert recycling plug completely and securely
into adapter. Install grass bag. See Figure 2.8.
FIGURE 2.8
WARNING
DO NOT operate without entire Grass Bag or guard
in place. Grass Bag components are subject to
deterioration during normal use. Inspect frequently
and replace worn or damaged components
immediately.
SECURE ADAPTER
TO DECK WITH NUTS
SECURE
WITH NUTS
ADAPTER
INSERT RECYCLING PLUG
COMPLETELY AND SECURELY
INTO ADAPTER. INSTALL
GRASS BAG.
ADAPTER
PLUG