background image

 

 

 

 

4

 

unit operation (cont.) 

 
STARTING THE ENGINE (cont.) 

 

  Bracing unit with one hand, grasp recoil handle 

and pull briskly. You may have to pull several 
times before engine starts. (If engine fails to 
start within a reasonable amount of time, 
discontinue and check engine manual for 
further instructions.)  Note: Do not allow recoil 
rope to snap back into recoil; damage to the 
rope or recoil could result.   

  After engine starts, move throttle control down 

to approximately half and turn off choke. 

 

 

TO SHUT ENGINE DOWN:

 

  Allow engine to idle for 2-3 minutes before shutting down. 

  Set throttle control fully back to slow (turtle) position. 

  If engine is not to be started for a prolonged period, turn fuel valve to closed position. 

 

IMPORTANT NOTE

: If you experience problems with your engine that cannot be satisfactorily resolved by following the 

instructions contained within the engine manual, contact your local engine dealer, or call the toll-free service number listed in 
the repair section of the engine manual.  All engine service, warranty or otherwise, is required to be performed by a 
manufacturer-authorized service center.  The equipment manufacturer is neither authorized nor responsible for any type of 
warranty engine service, nor is it equipped to perform any such service.  

 

BLOWER OPERATION

 

 

DANGER!  DO NOT PASS BY OR STAND ON THE AIR DISCHARGE SIDE OF ANY 
LEAF BLOWER WITH THE ENGINE RUNNING.  HIGH VELOCITY DISCHARGE CAN 
EASILY TURN HARMLESS DEBRIS INTO FLYING PROJECTILES. 

 

DANGER!  NEVER INSERT ANY BODY PART OR FOREIGN OBJECT INTO ANY 
OPENING WHILE UNIT IS RUNNING.  SERIOUS INJURY OR DEATH CAN RESULT. 

 

 

GENERAL RULES TO OBSERVE BEFORE  
AND DURING OPERATION: 

 

  Inspect your unit before each and every use.  Check for worn, bent or broken components, loose fasteners, 

low or flat tires, etc., and repair or replace prior to operation.  

DO NOT OPERATE A MACHINE THAT IS 

WORN OR DAMAGED – SERIOUS INJURY OR DEATH CAN RESULT.    

  Clear the entire work area of all debris that could cause damage to or become entangled in the unit.  Rocks 

and large branches can wedge themselves between the impeller and housing, causing equipment damage 
or personal injury.  If in doubt, remove it.  

 
 
 

PULL 
BRISKLY 

Summary of Contents for SLB55150BV













Reviews: