Maintenance
Washing the Mower Deck
The washout port allows you to connect a typical garden
hose to the trim side (L.H.) of the mower deck to remove
grass and debris from the underside of the deck. This
ensures proper and safe operation of the mower.
1. Park the rider on a smooth, level surface such as a
concrete floor. Disengage the PTO, lock the ground
speed levers into their START/PARK positions,
engage the parking brake, turn off the engine, and
remove the ignition key.
2. Attach the quick disconnect (
a
, Figure 12) to a gar-
den hose (
b
), and connect to the washout port (
c
)
on the mower deck.
3. Turn on the water.
4. Start the engine, set the mower deck in the high-
est cutting position, and engage the PTO to remove
grass and debris from the underside of the mower
deck.
5. Disengage the PTO, turn off the engine, and remove
the ignition key.
6. Remove the garden hose and quick disconnect from
the mower deck when cleaning is completed.
WaRNING
before running the mower, make sure the hose
is properly connected and does not come into
cotact with the blades. When the mower is
running and the blades are engaged, the person
cleaning the mower must be in the operator
position, and there must be no bystanders.
failure to follow these precautions may result in
serious injury or death.
figure 12. Mower Deck Washout Port
B
A
C
Storage
Before you store your unit for the off-season, read the
Maintenance and Storage
instructions in the
Operator
Safety
section, then perform the following steps:
• Disengage the PTO, move the ground speed levers
into the START/PARK positions, set the parking
brake, & remove the key.
• Perform engine maintenance and storage measures
listed in the engine owner’s manual. This includes
draining the fuel system, or adding stabilizer to the
fuel (do not store a fueled unit in an enclosed struc-
ture - see warning).
• Battery life will be increased if it is removed, put in a
cool, dry place and fully charged about once a month.
If the battery is left in the unit, disconnect the negative
cable.
Before starting the unit after it has been stored:
• Check all fluid levels. Check all maintenance items.
• Perform all recommended checks and procedures
found in the engine owner’s manual.
• Allow the engine to warm up for several minutes
before use.
WaRNING
Never store the unit (with fuel) in an enclosed,
poorly ventilated structure. fuel vapors can
travel to an ignition source (such as a furnace,
water heater, etc.) and cause an explosion.
fuel vapor is also toxic to humans and animals.
www.snapper.com
22
Not
for
Reproduction
Not
for
Reproduction
Summary of Contents for RZT26520
Page 31: ...31 en N o t f o r R e p r o d u c t i o n N o t f o r R e p r o d u c t i o n...
Page 32: ...www snapper com N o t f o r R e p r o d u c t i o n N o t f o r R e p r o d u c t i o n...
Page 63: ...31 es N o t f o r R e p r o d u c t i o n N o t f o r R e p r o d u c t i o n...
Page 64: ...www snapper com N o t f o r R e p r o d u c t i o n N o t f o r R e p r o d u c t i o n...
