Snapper MCRP215015KWV, Safety Instructions & Operator'S Manual

Page: 15 / 28

15
Section 4 - ADJUSTMENTS & REPAIR
WARNING
DO NOT attempt any maintenance, adjustments or
service with engine and blade running. STOP engine
and blade. Disconnect spark plug wire and secure
away from spark plug. Engine and components are
HOT. Avoid serious burns, allow sufficient time for
all components to cool.
4.3.4. Replacing Rubber Driven Disc
(Continued from previous page)
2. Using needle nose pliers, unhook the drive spring
and slide the driven disc assembly off the hex shaft.
See Figure 4.12.
3. Remove the two retaining rings which secure the
rubber driven disc to the driven disc assembly. See
Figure 4.13.
4. Install new rubber driven disc onto driven disc
assembly with retaining rings.
5. Reverse above procedures for reassembly and
installation of driven disc assembly.
FIGURE 4.12
4.3.5. Replacing Bearing In Driven Disc Assembly
If the driven disc bearing fails, remove the driven
disc assembly and replace bearing as follows:
1. Remove snap ring. See Figure 4.13.
FIGURE 4.13
2. Slide the hub assembly out of the bearing.
3. Remove the four screws.
4. Remove bearing and replace with new bearing.
5. Reassemble components in reverse order.
DRIVEN DISC
ASSEMBLY
THRUST PLATE
SNAP
RING
SHIM
WASHER
REMOVE FOUR
MACHINE SCREWS
BEARING
DRIVEN
DISC
PLATE
DRIVEN DISC
HUB
RUBBER DISC