LT-200 Series
3/2007
3
TP 300-4517-00-RG-N
Quick Setup List -
Page
Setup Procedure
Steps to Perform
4
Uncrating
o
Remove Crate & Banding.
o
Place Transmission Release Lever in PUSH position & Roll
Tractor forward off skid.
4
Battery Charging
&
o
Charge the Battery
(Note: proceed with other setup steps
Installation
while battery is charging).
o
Install Battery.
5
Check Fluid Levels
o
Check Transmission fluid level.
o
Fill & check Engine oil level.
6
SAFETY CHECKS
o
Check for LOOSE HARDWARE.
o
Check all OPERATOR CONTROLS.
o
Test PARKING BRAKE.
o
Perform MOWER BLADE STOPPING CHECK.
(Blade must stop within 5 seconds!)
o
Check the Seat Switch connection.
o
Perform SAFETY INTERLOCK SYSTEM CHECK.
7
Torque Mower Blades
o
Torque mower blades to 45-55 ft.lbs. (61-75 Nm.
7
Burnish Electric Clutch
o
Burnish Electric Clutch
(run for 15 seconds, repeat 10
times).
7
Reduce &
Check Tire Pressure
o
Reduce & check Tire Pressure.
(Front Tires 12-15 psi, Rear tires 10-12 psi)
8
Lubrication
o
Lubricate all grease & oil points.
10
Mower Assembly
o
Install Mower Deck onto Tractor and Attach Belt
o
Level Mower Deck (Side-to-side & Front-to-back).
14
Adjustment Procedures
o
Gauge Wheels.
