Snapper IMAGE 204094, Operating Manual, Page: 8 / 12

Pairing Additional Receivers (continued)
1. Turn the new receiver ON.
2. Press and hold (about 5 seconds) the PAIRING
button on the bottom of the receiver until the ON/
OFF indicator starts blinking. Pairing period is
approximately 20 seconds.
3. Press and hold (about 3 seconds) the PAIRING button
on the back of the base until the power indicator
starts blinking. It will start pairing with the new
receiver.
4. As soon as pairing is successful (less than 2
seconds), the new receiver’s ON/OFF indicator will
stop blinking, and audio sounds will be played within
5 seconds.
5. Repeat these steps again if pairing is not successful.
Using Headphones
Plug your headphones into the headphone jack as
shown. No sound will be emitted from the speakers.
Adjust the headphone volume by rotating the
volume knob.
Back of
transmitter
(Base)
Bottom
of receiver
(Speaker)
8 • Wireless TV Speaker