Snapper FAST-Vac, Operator'S Manual With Setup Instructions, Page: 14 / 24

12 www.snapperpro.com
Installation
Collector Installation
Figure 20. Install Mount Posts & Hitch Pins
A. Mount Post
B. Hitch Pin
C. 5/16-18 Bolts
A
B
Figure 21. Assemble Collector Hood
A. Collector Back Plate
B. Inlet Tube
C. 5/16-18 x 3/4” Bolt
D. 5/16-18 Nylock Flange Nut
E. Collector Mount Post
F. 3/8-16 x 1” Bolt
G. 3/8-16 Nylock Flange Nut
A
B
C
D
E
F
G
3 Bag Collector
Assemble Collector Hood
1. Install the inlet tube (B, Figure 21) to the collector
back plate (A) and secure with the 5/16-18 x 3/4”
bolts (C) and 5/16-18 nylock flange nuts (D).
2. Install the mount posts (E) on the back plate and
loosely secure with the 3/8-16 x 1” bolts (F) and
3/8-16 nylock flange nuts (G).
NOTE: On the 3-bag collector back plate, install the
eight (8) supplied hole plugs in the remaining
mounting holes not used.
3. Install the collector onto the mount plate and
secure with the hitch pins. Again, this will insure
that the holes are properly aligned for easy
installation and removal.. Tighten the 3/8-16 x 1”
bolts securing the posts to the back plate.
Install Mount Posts
1. Temporarily install the collector mount posts (A,
Figure 20) into the collector plate and install the
hitch pins (B). This will insure that the holes are
properly aligned for easy installation and removal.
2. Tighten the 5/16-18 bolts (C) that mount the
bagger mount bracket to the bagger mount plate
securely and remove the hitch pins and mount
posts.
C