11
Section 4 - ADJUSTMENTS & REPAIR
WARNING
Before attempting any adjustments or repairs, STOP
the engine, remove the spark plug wire from the
spark plug and secure wire away from plug. Wear
heavy leather gloves when handling or working
around cutting blades. Blades are extremely sharp
and can cause severe injury.
4.1 MOWER BLADE REPAIR/REPLACEMENT
4.1.1. STANDARD BLADE WEAR LIMIT
1. Inspect blade frequently for signs of excessive wear
or damage. See Figure 4.1.
FIGURE 4.1
4.1.2.
NINJA BLADE WEAR LIMIT
1. Inspect blade frequently for signs of excessive wear
or damage. See Figure 4.2.
FIGURE 4.2
2. Replace the blade if it is badly chipped, bent,
noticeably out of balance or has cracks or notch in
either tip. See Figure 4.1 & 4.2. Replace with new
blade.
WARNING
Never use a cutting blade that shows signs of
excessive wear or damage. Refer to Section on
MOWER BLADE REPAIR/REPLACEMENT for proper
blade inspection and service procedures.
4.1.3. BLADE SHARPENING
1. Disconnect spark plug wire and secure end away
from plug.
IMPORTANT: DO NOT tip machine with carburetor or
spark plug down. Oil from crankcase will saturate the air
filter and cause the engine to be hard to start or not start at
all. If contamination does occur, the air filter will have to be
replaced.
2. Tilt mower up on its rear wheels.
3. Remove blade. See Figure 4.3.
FIGURE 4.3
NEW
BLADE
WEAR LIMIT
(NOTCH STARTS)
DANGEROUS
CONDITION!
DO NOT USE ON
MOWER! REPLACE
WITH NEW BLADE.
NEW BLADE
WEAR LIMIT. CRACKS
OR NOTCHES BEGIN
TO APPEAR ON TIP.
DANGEROUS!
DO NOT USE A BLADE IN
THIS CONDITION!
MAKE SURE THAT
BLADE HUB IS
SEATED BETWEEN
FLANGES
BLADE
HUB
FLANGE
BLADE
CONE WASHER
(Concave Side Up)
CAPSCREW
Summary of Contents for EMRP215014B
