2
C. ADAPTER INSTALLATION
Hold the adapter in front of the deck. Align the adapter
lugs with the hinge lug retainers, and then push the
adapter to the rear.
Loosen bolts (see Figure 2C) & bump the adapter, if
necessary, to force the lugs under the lug retainers.
Secure the adapter to the deck with a flat washer and
wing nut. Tighten bolts. See Figure 2C.
FIGURE 2C
STEP 3: COVER/FRAME INSTALLATION
Lower cover/frame structure into position on bumper. Secure each side of structure as follows: Insert one 5/16 x 1-11/16”
clevis pin through top hole at each side of cover/frame structure as shown in Figure 3 and secure with 3/32 x 1-1/2” hairpin
cotter.
NOTE
: When Rear Engine Rider is equipped with two-piece post style bumper (as shown in Figure 1) install clevis pin in
lower hole at each side of cover/frame structure.
FIGURE 3
HAIRPIN
COVER/FRAME
ASSEMBLY
CLEVIS
PIN
GRASS
CATCHER
LATCH
BUMPER
HINGE LUG
RETAINERS
LOOSEN
BOLTS IF
NECESSARY
FLAT WASHER
WING NUT
BOLT
ADAPTER SHOWN
IN OPERATING
POSITION
ADAPTER
ADAPTER
LUGS
RETIGHTEN
BOLTS
PUSH ADAPTER TO
THE REAR TO SEAT
LUGS UNDER RETAINERS
33” DECK
