Snapper 1695549, Operator'S Manual

Page: 19 / 76

OPERATION
Pushing the Tractor by Hand
1. Disengage the PTO and turn the engine off.
2. Push the lever approximately 2-3/8” (6 cm) to release
the transmission ( B , Figure 3).
3. The tractor can now be pushed by hand.
DO NOT TOW TRACTOR
Towing the unit will cause transmission dam-
age.
• Do not use another vehicle to push or pull
this
unit.
• Do not actuate the transmission release
valve lever while the engine is running.
Attaching a Trailer
The maximum horizontal drawbar force allowed is 63 lbs
(280 N). The maximum vertical drawbar force is 36 lbs
(160 N). This equates to a 250 lb (113 kg) trailer on a 10
degree hill. Secure the trailer with a clevis pin (
A , Figure
5) and retaining clip ( B ).
Adjusting Mower Cutting Height
The mower lift lever ( A , Figure 4) controls the mower cut-
ting height. The cutting height is has seven positions be-
tween approximately 1-1/4” and 4” (3,2-10,2 cm).
Stopping the Tractor and Engine
1. Return the ground speed control(s) to NEUTRAL.
2. Disengage the PTO and wait for all moving parts to
stop.
3. Move the throttle control to SLOW position and turn
the ignition key to OFF. Remove the key.
WARNING
Fuel and its vapors are extremely
fl ammable and explosive.
Fire or explosion can cause severe burns or
death.
• Do not choke the carburetor to stop engine.
WARNING
Mowing in reverse can be hazardous to bystanders.
Tragic accidents can occur if the operator is not
alert to the presence of children. Never activate
RMO if children are present. Children are often
attracted to the unit and the mowing activity.
Mowing in Reverse (RMO)
Attachment Operation in Reverse
If an operator chooses to operate a PTO driven attach-
ment in reverse, the RMO system can be used. To use
the Reverse Mowing Option (RMO) turn the RMO key
after the PTO is engaged. The L.E.D. light will illuminate,
and the operator can then operate the attachment in re-
verse. Each time the PTO is disengaged the RMO needs
to be reactivated if desired. The key should be removed
to restrict access to the RMO feature.
19
If an operator chooses to mow in reverse, the RMO sys-
tem can be used. To use the Reverse Mowing Option
(RMO) turn the RMO key after the PTO is engaged. The
L.E.D. light will illuminate, and the operator can then mow
in reverse. Each time the PTO is engaged the RMO needs
to be reactivated if desired. The key should be removed
to restrict access to the RMO feature.
en
Not
for
Reproduction