Motorhome Detailed Installation Instructions
EQ ROUND INSTALLATION INSTRUCTIONS
RV SNAPPAD 02
INSTALLATION TIME: 3 - 6 MINUTES PER PAD.
• SnapPad installation is best performed on a level or near level surface – preferably a hard surface (concrete or asphalt). Wheel chocks
can be placed in front of and behind the RV wheels for additional safety.
• Be sure to thoroughly clean and dry your landing feet prior to installing your SnapPads.
• Spread a small bead of concentrated dish soap around the lip of the SnapPad and metal landing foot to aid installation.
Do NOT use
any petroleum based lubricant, such as WD-40®, as it may negatively react with the binder in your SnapPads.
• Most motorhomes will release their airbags prior to engaging the jacks. This will lower the entire RV at the beginning of the leveling
process. You may place your first SnapPad prior to this, however,
be careful to not get caught underneath your RV during the
lowering process!
• Typically one side will level first. Take note which side that is and start there. Install one SnapPad at a time and/or use the manual
jack operation if possible. Refer to your owners manual for instructions.
• Most jacks are 18”- 24” under your RV. A tool such as a broomstick to align/adjust your SnapPads may be necessary.
• Once aligned, begin lowering your jack. Keep an eye on the landing foot as it extends. Stop extending when the foot is about 2 to 3
inches from the SnapPad. Double check to make sure it is centered, re-align if necessary and then continue extending the landing
gear to complete installation.
KEEP YOUR FINGERS AND ANY FOREIGN OBJECTS CLEAR WHEN LOWERING THE
JACK INTO PLACE.
• You should hear a distinctive “snap” as the lip engages. Visually confirm the lip is fully engaged around the perimeter of the landing
foot.
• If your lip hasn’t fully engaged raise your jack and place a shim (small piece of wood no thicker than 1/4”) under the side that hasn’t
engaged. Lower your jack again until that side snaps into place.
• Wipe o
ff
any excess soap and repeat the installation process, in sequence, on your remaining jacks.
INSTALLATION TIME: 3 - 6 MINUTES PER PAD.
