Multiple Amplifier (Continued)
Controller Wiring
The M-801e is packed with control options:
• USB:
Used for firmware update.
• ETHERNET:
Two 100BaseT connections to a home network or to daisy chain other amplifiers.
• CONTROLLERS:
C12VDC, IR and data between the M-801e and KP-6 keypad controllers,
connected using CAT5 cables.
• BUS RUN:
For future use.
• TRIGGERS:
+12VDC 100mA trigger output when a zone is on.
FIGURE 3
9
In large installations where multiple M-801e
amplifiers are required, Ethernet conveys
amplifier control, and link to other Media
sources if connected to the Home network
Router or Switch. Ensure all amplifiers
using same the amp ID in the stack.
The source equipment audio inputs must
be plugged into the first amplifier where
they are buffered and sent to the next
amplifier in the stack. The maximum
recommended expansion is 24 units.
Fig 2. shows a stack of M-801e with Source
connections to first amplifier where they are
converted to Digital audio, buffered and sent
to the next amplifier in the stack. Use good
quality Coax Digital Shielded RCA cables for
the interconnection, cables should be no
more than 3 meters or 10 feet. The maximum
recommended expansion is twelve units.
* This chaining of Ethernet is an
option but a direct connection to
the router is the best option.
Summary of Contents for Mirage Autonomic MAS M-801e
Page 1: ...MAS m 801e 4 room Digital Amplifier with eAudioCast ...
Page 2: ......
