Snap-On VERDICT, User Manual

Page: 125 / 214

117
Scope Multimeter Operations Getting Started
Figure 9-1
Red Channel 1 Lead
Channel 2 Lead
The shielded green lead ( Figure 9-2 ) with an integrated probe is used for Channel 2. The lead
color matches the color of socket 2 on the Scope Multimeter and the color of trace 2 on the test
screens.
Figure 9-2
Green Channel 2 lead
Common Lead
The black lead ( Figure 9-3 ) with an integrated probe is used when a separate common, or ground,
connection is needed. The lead color matches the color of the GND socket on the Scope
Multimeter.
Figure 9-3
Red Channel 4 lead
Alligator Clips
Three insulated alligator clips that attach to the test leads are included. The insulator boots are
colored to match each test lead. Alligator clips attach to the probe end of the test lead.
z
To install an alligator clip:
1. Remove the collar from the probe by threading it counterclockwise off of the tip ( Figure 9-4 ).
Store the collar in a safe place while not in use.
Figure 9-4
Probe collar
2. Fit the tip of the probe into the alligator clip and thread the clip onto the probe.