Snap-On ControlTech CTLNK1R240, Manual

Page: 26 / 36

6.
SET TIME screen is displayed with hour highlighted.
7.
Use UP/DOWN buttons to set hour then press ENTER button to highlight minutes.
8.
Use UP/DOWN buttons to set minutes then press ENTER button to highlight seconds.
9.
Use UP/DOWN buttons to set seconds then press ENTER button.
10.
Clock is set and Configure menu is displayed.
Note: Year selection will scroll up from 2014. Month selection will scroll from 1 to 12. Day selection will scroll
from 1 to 31.
Note: Hour selection will scroll through 0 to 23. Minute and Second selections will scroll through 0 to 59.
Note: If batteries are removed from wrench for longer than 20 minutes, clock will revert to default settings and
must be re-entered at power on.
Setting Calibration Interval
This function will allow user to set calibration interval for when "CAL NEEDED" message will be displayed.
1.
From Configure menu, use UP/DOWN buttons to highlight SET CAL INTRVAL selection then press ENTER
button.
2.
CAL INTERVAL screen is displayed.
3.
Use UP/DOWN buttons to change calibration interval.
Selectable Intervals:

12 MON (factory default)

6 MON

3 MON

DISABLED
4.
Press ENTER button to accept selection and exit to Configure menu.
ENTER
button
CAL INTRVAL
12 MON
EXIT
JOB MODE
CALIBRATION
SET DATE/TIME
SET CAL INTRVAL
ENTER
button
UP/DOWN buttons
CAL INTRVAL
DISABLED
EXIT
SET DATE
2014 /01/01
YR MON DAY
SET DATE
2014/
01 /01
YR MON DAY
SET DATE
2014/01/
01
YR MON DAY
DELELTE PRESETS
JOB MODE
CALIBRATION
SET DATE/TIME
ENTER
button
UP/DOWN buttons
ENTER
button
UP/DOWN buttons
ENTER
button
UP/DOWN buttons
SET TIME
12 : 00 : 00
HR MIN SEC
SET TIME
12 :
00 : 00
HR MIN SEC
SET TIME
12 : 00 :
00
HR MIN SEC
UP/DOWN buttons
ENTER
button
UP/DOWN buttons
ENTER
button
UP/DOWN buttons
ENTER button
ENTER button