Snap-On Diagnostics DGA 1000, Manual, Page: 30 / 116

1-18
Introduction
\
✓
An optional 12V power adapter, part number 2-2650, is
also available. This allows the analyzer to be powered by
a vehicle battery.
3. Inser t the keyboard connector to the keyboard por t (U).
4. Connect the exhaust sample probe to the sample gas
por t (N).
5. Inser t the RPM pickup lead into the RPM pickup
por t (M).
6. Inser t the optional oil temperature probe into the oil
temperature probe por t (L).
Connecting to a Vehicle
1. Inser t the exhaust gas probe into the vehicle tail pipe.
Make sure the sample probe is fully inser ted.
2. Connect the RPM pickup as follows:
—
Use the grey inductive pickup, part number
6004E9312-95, when a spark plug wire is available to
connect the clamp, preferably near the distributor.
✓
Tests may be performed without an RPM connection.
✓
An optional orange capacitive pickup, part number
6004E9313-19, is available when a spark plug wire is not
accessible. Connect it to an injector body (cylinder No.1),
to the outside of the insulation of an injector wire, or a
group of injector wires (max. three).
✓
Route the pickup lead clear of any moving parts.
Figure 1-10 : Back Panel