7
GMV SnapDrill 2021
6 Changing of hole cutter
1.
Referring to fig. 6, screw out lock screw and remove the hole cutter.
2.
Thoroughly clean all visible parts. Using air pressure to clean is not recommended. Insert the new
hole cutter.
3.
It is important that the battery drill is set to gear stage 1. Fasten the hole cutter with the custom
socket and flex handle.
4.
The table below gives the hole cutter part number and its size that fit for each SnapDrill. Note
that for cutter Ø24 and Ø30 there is a short (S) and a long (L) version.
SnapDrill part
number and
pipe size (mm)
SD42,4/48,3-
Ø42,4 and
Ø48,3
SD60,3
Ø60,3
SD76,1
Ø76,1
SD88,9
Ø88,9
SD114,3
Ø114,3
SD168,3
Ø168,3
Hole cutter part
number and
cutter size (mm)
SD030S -Ø30
SD024S -Ø24
SD046L -Ø46
SD044L -
Ø44,5
SD038L -
Ø38,1
SD030L -Ø30
SD024L -Ø24
SD050L -Ø50,8
SD046L -Ø46
SD044L -Ø44,5
SD038L -Ø38,1
SD030L -Ø30
SD024L -Ø24
SD050L -Ø50,8
SD046L -Ø46
SD044L -Ø44,5
SD038L -Ø38,1
SD030L -Ø30
SD024L -Ø24
SD063L -Ø63,5
SD050L -Ø50,8
SD046L -Ø46
SD044L -Ø44,5
SD038L -Ø38,1
SD030L -Ø30
SD024L -Ø24
SD063L -Ø63,5
SD050L -Ø50,8
SD046L -Ø46
SD044L -Ø44,5
SD038L -Ø38,1
SD030L -Ø30
SD024L -Ø24
