215
| SMSEagle NXS-9700
| User’s Manual
When the device is not reachable
1.
Check if the device is correctly connected to the network. Check LED status of RJ45 socket.
2.
In the case when the device does not respond due to a malfunction or incorrect user settings please
reboot the device by disconnecting and connecting power source (or pressing Reset switch).
3.
If you still cannot connect with the device, it is possible to restore to factory IP settings by using the
SW button.
Restoring factory defaults
This action restores the following settings to default values:
IP settings, time zone settings, database
content
,
Linux OS users/passwords
In order to restore factory defaults, proceed with the following steps:
LED signaling
USER actions
System reaction
1.
When the device is
ready to operate
2.
Press and hold SW
button for 10 seconds
Restore service is counting
down.
3.
Release SW button
after 10 seconds.
User LED will begin to
blink.
System is reading factory
defaults.
Factory settings are being
applied to the device.
Summary of Contents for NXS-9700-3G
