User Manual
Page 11 of 12
SMSC CONFIDENTIAL
Revision 0.1 (8.26.2011)
5. Installation Requirements
The DWPCIe83 must be installed in a device that contains a 52-pin PCIE slot for mini-PCie cards.
The DWPCIe83 has FCC single modular approval, which can eliminate the need for you to obtain
FCC Part 15 Subpart C and E (intentional radiation) approvals for your device. In order to use this
FCC/IC single modular approval for the DWPCIe83, OEM integrators must:
1. include “Contains FCC ID: ZQO-DWPCIE83, IC: 2581A-DWPCIE83” on the exterior label of
your device.
2. ensure that its “END” product is electrically identical to the SMSC reference designs
3. use an antenna as approved with the DWPCIe83 module or an equivalent type antenna with
equal or lower gain and provide antenna reports to SMSC.
4. include all required statements in your final product user’s manual and final product labeling
as required by the applicable law in all respects. Refer to FCC/IC Information in previous
chapter (for illustration purposes only).
5. not provide Instructions on how to remove or install the DWPCIe83 module to your end users.
6. provide reg3.3 VDC power to the DWPCIe83 module.
Additional items (CE):
1. the module is tested to comply with the requirement of the R&TTE Directive. System
integrators are responsible for compliance of the final device with the R&TTE Directive.
2. Packaging: CE Marking must also be on the outer packaging of the product. The outer
packaging must also provide an indication as to where the device is intended to be used and
OR conversely, where there may be restrictions to use.
IMPORTANT NOTE:
In the event that these conditions cannot be met (for example certain laptop configurations or co-
location with another transmitter), then the FCC authorization is no longer considered valid and FCC
ID cannot be used on the final product. In these circumstances, the OEM integrator will be
responsible for re-evaluating the end product (including the transmitter) and obtaining a separate FCC
authorization.
Manual Information to the End User
The OEM integrator has to be aware not to provide information to the end user regarding how to
install or remove this RF module in the user manual of the end product which integrates this module.
The end user manual shall include all required regulatory information/ warning as shown in this
manual (for illustration purpose only).
CONFIDENTIAL FOR
Neutron Engineering Inc.
ONLY