Pg. 3
Authorized Part numbers listed below
To comply with FCC rules,
this booster must only be operated with cables, antennas and
coupling devices that have been approved for use with this equipment.
For specifications of any of the Smoothalker FCC approved part numbers listed
below
visit smoothtalker.com
Authorized Magnetic base Antennas
SEM2MX, SEM11MX, SEM15MX,
SEM2MX, SEM11MX, SEM15MX,
SEM2MXL, SEM11MXL, SEM15MXL,
SEM2LGMX, SEM11LGMX, SEM15LGMX,
SEM26LGMX, SEM2LGMXL, SEM11LGMXL,
SEM15LGMXL, SEM26LGMXL
Authorized thru-hole Antennas
SEM2THX, SEM11THX, SEM15THX,
SEM26THX, SEM2THXL, SEM11THXL,
SEM15THXL, SEM26THXL
Authorized Inside antennas
SEMR P1X, SEMR P1XL, SEMR1
Authorized Co-ax Cables
ACX100 extension cable
ACX900 extension cable
AC series antenna connection
Authorized directional Antennas
SEMD1XL, SEMDA2XL,
Initial Setup Assembly & Installation
1- First make sure that no power is connected to the booster. Connect the inside
antenna, the outside antenna and power supply to the booster. Please make sure to
connect each item in to the correct ports as indicated on the booster.
2- Place the antenna on the outside of the vehicle or building and keep it separated
as far as possible from the inside antenna or cell phone holder.
3- Turn the power switch to ON position and the single Green LED on the side of the
unit will become Green, constant ON, to indicate that power is reaching the booster
and that it is turned on.
Operation:
PLEASE NOTE:
It is normal for the booster to be quite warm during cell phone “in use” state.
LED
Light Indicators on
Panel Label:
Orange LED Lights (RX):
Green LED Lights (TX):
There two orange LED lights, one for the
800MHz cellular band and one for the
1900MHz PCS band. LED ON state indi-
cates that the RX (Receive Signal) function of the band is functioning normally. LED
Off state indicates that the band is shut down.
There two Green LED lights, one for the 800MHz cellular band and one for the
1900MHz PCS band. Solid ON state indicates that the TX (Transmit Signal) function
of the indicated band is on and is at maximum gain. Flashing Green LED in either
800MHz or 1900MHz indicates gain reduction in that band Each flash equals 3db
reduction in gain. One flash represents a 3dB reduction, two flashes represents a
6dB reduction etc. until the total gain of the booster has been suppressed. Causes of
Flashing Green LED Lights:
1- If the outside antenna is located too close to the inside antenna or phone holder
the booster will reduce gain in order to suppress any oscillation (feedback loop) and
the Green LED will flash. To achieve higher gain or max gain further separation of the
inside and outside antennas is required.
2- If the booster is close to a cellular tower (Strong cell tower signal ) it will automati-
cally reduce its gain to protect the network. This condition will change as the booster
approaches or leaves a cellular tower. This is normal and cannot be defeated or
altered by the user.
Inside
Antenna
Outside
Antenna
DCH6HV: AC/DC Wall
6V Power supply
DCH6i: 6V Power
Supply; Install type
DCH6Csw:
DC 6V Power
Cigar Socket
type Adapter
Pg. 2
